Campbell Scientific TX312 High Data Rate GOES Transmitter - Manual (Page 61)

Appendix D. RAWS-7 Data Format
D-13
; At the top of the 3rd hour, move hourly data values
; to the "new" place holders
76: If time is (P92)
1: 60
Minutes (Seconds --) into a ;changed 3/31/0
2: 180 Interval (same units as above)
3: 10 Set Output Flag High (Flag 0)
77: Set Active Storage Area (P80)
1: 3
Input Storage Area
2: 18 Loc [ MaxWD_New ]
78: Sample (P70)
1: 1
Reps
2: 13 Loc [ WDHrMxWS ]
79: Set Active Storage Area (P80)
1: 3
Input Storage Area
2: 21 Loc [ MaxWS_New ]
80: Sample (P70)
1: 1
Reps
2: 12 Loc [ MaxHrWS ]
81: Set Active Storage Area (P80)
1: 3
Input Storage Area
2: 24 Loc [ SRad_New ]
82: Resolution (P78)
1: 1
High Resolution
83: Average (P71)
1: 1
Reps
2: 9 Loc [ SRad ]
84: Resolution (P78)
1: 0
Low Resolution
85: Set Active Storage Area (P80)
1: 3
Input Storage Area
2: 27 Loc [ FM_New ]
86: Sample (P70)
1: 1
Reps
2: 28 Loc [ FuelM ]
; **********************************************
; Data values beyond RAWS-7, written to final
; storage and copied to transmitter
; **********************************************
; Write wind direction of the max wind speed, max wind speed,
; average solar radiation and fuel moisture to FS 1 and the GOES transmitter.
; Format will look like: