Campbell Scientific TX312 High Data Rate GOES Transmitter - Manual (Page 25)

TX312 Transmitter
TABLE 5.1-3. GoesStatus Command 2: Read Last Message Status
Index Contents
1 Command Result Code
2 Message type: Self-timed or Random
3 Size of message in bytes
4 Forward power in tenths of watts
5 Reflected power in tenths of watts
6 Power supply voltage under full load, in tenths of volts
7 GPS acquisition time in tens of seconds
8 Oscillator drift (signed, hundreds of Hz)
9 Latitude degrees
10 Latitude minutes
11 Latitude seconds
12 Longitude degrees
13 Longitude minutes
14 Longitude seconds.
5.1.2.4 GoesStatus Read Error Register
Example:
Public Errors(10)
GoesStatus(Errors(), 4)
Command 4 (Read Error Register) is used to return the total number of errors
that have occurred, and codes describing the last four errors. When the
command that caused the error is listed as 31, the error is an internal fault.
Otherwise the error is just a communication error.
TABLE 5.1-4. GoesStatus Command 4: Read TX312 Error Registers
Index Contents
1 Result Code
2 Number of Errors
3 Command that Caused the Error
4 Error Code
5 Command that Caused the Error
6 Error Code
7 Command that Caused the Error
8 Error Code
9 Command that Caused the Error
10 Error Code
19