Campbell Scientific NL240 Wireless Network Link Interface - Manual (Page 17)

NL240 Wireless Network Link Interface
Campbell Scientific’s LoggerNet software is used to communicate with the
dataloggers once the NL240 is configured properly and connected to a
network.
Bridge Mode
• Allows access to datalogger’s internal IP functionality when a peripheral
port is not accessible. For example, accessing the HTTP/webpage, email,
and FTP capabilities of a CR800/850, ET107, RAWS, or CS110.
Serial Server
• Allows access to a CR10X over a Wi-Fi network (RS-232 serial server)
when used in conjunction with an RS-232 to CS I/O (ME) adapter like the
SC32B or SC105.
• Allows access to a serial sensor over a Wi-Fi network (RS-232 serial
server).
• Allows access to an RF500M Base over a Wi-Fi network (RS-232 serial
server).
PakBus® Router
• Allows access to a CR10X-PB over a Wi-Fi Network.
• Allows access to a CR200X over a Wi-Fi Network.
• Allows you to connect to a PakBus® Device on the RS-232 port and a
PakBus Device on the CS I/O port using only one TCP port.
• Allows a PakBus® device on the RS-232 port and a PakBus device on the
CS I/O port to communicate with each other without routing through the
WLAN.
• Allows multiple computers to concurrently talk to PakBus® devices
connected to the RS-232 and CS I/O ports.
TLS Proxy Server
• Adds an encrypted WLAN interface to a datalogger that supports CS I/O
IP (bridge mode) communications.
7