Campbell Scientific EnviroSCAN Sentek Water Content Profile Probe User Manual

Page 4

EnviroSMART

Table of Contents

B. Normalization and Function Test

........................... B-1

B.1 Normalization...................................................................................... B-1

B.1.1 Water Content Only................................................................... B-2
B.1.2 TriSCAN Normalization............................................................ B-4

B.2 Configuration Testing.......................................................................... B-5

C. Access Tube Installation

........................................C-1

C.1 Standard Access Tube Installation ...................................................... C-2

C.1.1 Installation Tools ....................................................................... C-2
C.1.2 Installing the Access Tube......................................................... C-3
C.1.3 Cleaning the Access Tube.......................................................... C-4
C.1.4 Installing the Bottom Stopper Bung .......................................... C-5
C.1.5 Installing the Top Cap ............................................................... C-5

C.2 Access Tube Removal ......................................................................... C-6

D. Site Selection

...........................................................D-1

E. SDI-12 Commands

................................................... E-1

Figures

1. EnviroSMART

SDI-12 Interface ........................................................... 5

A-1. Finished EnviroSMART

Assembly ............................................... A-1

A-2. Probe Rod Top ................................................................................... A-1
A-3. Location of Large Handle Screws...................................................... A-1
A-4. Location of Small Main Board Screws .............................................. A-2
A-5. Securing Main Board Electrical Connection...................................... A-2
A-6. Possible Sensor Positions................................................................... A-2
A-7. Sensor Orientation ............................................................................. A-3
A-8. Sensor Ribbon Cable.......................................................................... A-3
A-9. Locking Sensor in Place..................................................................... A-3
A-10. Aligning Sensor Tab with Probe Slot............................................... A-4
A-11. Plugging in Ribbon Cable Header ................................................... A-4
A-12. Sensor Addresses ............................................................................. A-4
A-13. Location of Addressing Jumpers...................................................... A-5
A-14. Location of Jumper 1 ....................................................................... A-5
A-15. Location of Jumper 2 ....................................................................... A-5
A-16. Location of Jumpers 1..16................................................................ A-6
B-1. SDI-12 Interface Power Connection .................................................. B-1
B-2. SDI-12 Interface TTL Connection ..................................................... B-1
B-3. IPConfig Utility Icon.......................................................................... B-2
B-4. IPConfig Probe Configuration Window............................................. B-2
B-5. IPConfig Probe Configuration Window for TriSCAN....................... B-4
B-6. IPConfig Configuration Test Window ............................................... B-5
C-1. Incorrect Installation .......................................................................... C-3
C-2. Installation Toolkit #1 ........................................................................ C-7
C-3. Installation Toolkit #2 ........................................................................ C-7