Campbell Scientific CM6/CM10 Tripod Weather Station Installation - Manual (Page 40)

Section 3. Instrumentation Installation
2. Seal around the sensor leads where they enter the enclosure. Place a roll
of putty around the sensor leads and press it around the leads and into the
coupling to form a tight seal.
3. Remove the RH indicator card and two desiccant packs from the sealed
plastic bag. Remove the backing from the indicator card and attach the
card to the right side of the enclosure.
The humidity indicator card has three colored circles which indicate the
percentage of humidity. Desiccant packs inside the enclosure should be
replaced with fresh packs when the upper dot on the indicator begins to
turn pink. The indicator card does not need to be replaced unless the
colored circles overrun.
DO NOT EAT
UNITED DESICCANTS-GATES
101CHRISTINE, BELEN, NEW MEXICO 87002
DESI PAK
SPECIFICATION MIL-D-3464 TYPE I &II
REACTIVATION TIME IN-BAG 16 HOURS AT 250 F
DESICCANT
ACTIVATED
BAGGED FOR
CONTENTS
4
UNITS
PACKAGE USE
AND STATIC
DEHUMIDIFICATION
DO NOT EAT
UNITED DESICCANTS-GATES
101CHRISTINE, BELEN, NEW MEXICO 87002
DESI PAK
SPECIFICATION MIL-D-3464 TYPE I &II
REACTIVATION TIME IN-BAG 16 HOURS AT 250 F
DESICCANT
ACTIVATED
BAGGED FOR
CONTENTS
4
UNITS
PACKAGE USE
AND STATIC
DEHUMIDIFICATION
INDICATOR HUMIDITY
MS20003-2
EXAMINE
ITEM
IF PINK
CHANGE
DESICCANT
IF PINK
WARNING
IF PINK
AVOID METAL CONTACT
DISCARD IF CIRCLES OVERRUN
Humidial Corp., Colton Calif.
FIGURE 3.4-1. Enclosure Supply Kit
3-16