Summary of functions, Operating philosophy, Change main function – Flytec Windwatch Pro User Manual
Page 4: Change sub function, Backlight, Summary of functions operating philosophy
4
Introduction
Congratulations!
on your purchase of the pocket weather station Windwatch PRO
This operation manual provides detailed information about the operating mode of the
Windwatch PRO
instrument. By using your new, multi function instrument which is equipped
with four high precision sensors, you are able to measure wind, air pressure, altitude,
temperature and relative air humidity. Moreover, your pocket weather station provides the
feature of Windchill and dew point calculation, as well as very useful functions for timer, alarm
and alarm clock. The purpose of this operating manual is to make yourself familiar with the easy
handling of the instrument and to stimulate at the same time the comprehension for
meteorological correlation. Some more comments related to meteorology-physical conditions
are specifically addressed to the ambitious user.
Summary of Functions
The Windwatch PRO provides the following six main function screens, shown with
corresponding symbols that are visible in the upper part of the display:
Sub
function
Wind Gauge
Sub
function
Sub
function
Stop Watch
Timer
Time
Alarm Clock
Sub
function
Barometer
Altimeter
Humidity
Temperature
Sub
function
Sub
function
Within any main function screen it is possible to access one or two sub-screens
Operating Philosophy
Change Main function:
A short press of the MENU key scrolls, in a loop, from one main screen to the next main
screen (see page 6 chart of functions).
Change Sub function:
A short press of the SUB key scrolls through the possible sub-screens within each main
screen.
2
Backlight
Long-press
the MENU key for 2 seconds to activate the display backlight. The backlight
consumes higher-than-normal battery power; therefore it is recommended that it only be used
when the display could otherwise not be read. When the battery condition is weak, the backlight
function is automatically disabled and a “No Li” message is briefly shown in the display upon the
next menu change. All other functions of the instrument remain operative until the battery is
completely exhausted.