Siemens HC724220 - Manual (Page 79)

79
3. Fold back both locking levers (figure C). Close the oven
door.
ã=
Risk of injury!
If the oven door falls out accidentally or a hinge snaps shut, do
not reach into the hinge. Call the after
­sales service.
Removing and installing the glass panels
The glass panels on the oven door can be removed to allow
more thorough cleaning.
When removing the inner panels, make sure that they are
refitted in the same order.
Removal
1. Detach the oven door and lay on a cloth with the handle
facing down.
2. Unscrew the cover at the top of the oven door. To do this,
undo the left and right screws (fig. A).
3. Lift the top panel up and out (fig. B).
4. Unscrew the retaining clips on the right and left and remove
them (fig. C). Remove the middle panel.
5. Pull the lower panel diagonally upwards and out.
Clean the panels with glass cleaner and a soft cloth.
Do not use sharp or abrasive materials or a glass scraper. This
may damage the glass.
Installing
1. Insert the lower glass panel diagonally towards the back
(Fig. A). Make sure that the lettering "top right" is not upside
down at the bottom left.
2. Insert the middle glass panel (Fig. B).
3. Place the left and right securing brackets on the glass panel
and align the springs on the bolt hole and screw tight
(Fig. C).
4. Insert the upper glass panel diagonally towards the back. The
smooth surface must face outwards.
5. Put the cover back in place and screw it on.
6. Attach the oven door again.
The oven may only be used again when the panels are
correctly installed.
&
% $
&
% $
&