Siemens HC724220 - Manual (Page 71)

71
operation. The fronts of adjacent units could be damaged.
Always keep the oven seal clean.
■
Oven door as a bearing surface: do not stand or place
objects on the oven door when it is open. Do not place
ovenware or accessories on the oven door.
■
Carrying the appliance: do not carry or hold the appliance by
the door handle. The door handle cannot support the weight
of the appliance and could break.
Plinth drawer
Caution!
Do not place hot objects in the plinth drawer. It could be
damaged.
Installation and connection
Electrical connection
The appliance must be connected to the mains by a licensed
expert. The regulations of your electricity supplier must be
observed.
Any damage arising from the appliance being connected
incorrectly will invalidate the guarantee.
For the installer
■
An all-pole isolating switch with a contact gap of at least
3 mm must be present in the installation circuit. This is not
necessary if the appliance is connected by a plug that is
accessible to the user.
■
Electrical safety: The cooker corresponds to safety class I
and may only be used in conjunction with a safety earth
terminal.
■
A type H 05 VV-F or equally rated lead must be used to
connect the appliance.
■
Appliances with a plug must only be connected to a properly
installed socket with maximum 25 A, 3x4 mm².
Levelling the cooker
Always place the cooker directly on the floor.
1. Pull out the plinth drawer and lift it up and out.
There are adjustable feet at the front and rear on the inside of
the plinth.
2. Use an Allen key to raise or lower the adjustable feet as
necessary until the cooker is level (picture A).
3. Push the plinth drawer back in (picture B).
Wall fixing
To prevent the cooker from tipping over, you must fix it to the
wall using the enclosed bracket. Please observe the installation
instructions for fixing the oven to the wall.
% $