Princeton Tec POINT HAT CLIP - Manual (Page 2)

resistant. Check the light for water
contamination on the circuit board. The light
will resume normal operation once any water
is shaken or blown out and the light is left
open until completely dry. If the light has been
contaminated with salt water, flush the unit
with fresh water and dry as described above.
USA Lifetime Warranty– International
10-Year Warranty
Princeton Tec reserves the right to change product
specifications without notice.
Return Policy
If your light fails to operate, follow these simple
steps:
1) Check batteries. Replace if necessary.
2) Contact Princeton Tec customer service at
800-257-9080 to request an RMA number to send
your light in for repair or replacement. No
warranty repairs will be accepted without an
RMA number.
3) Return the light without batteries to:
Princeton Tec, 5198 Rt. 130, Bordentown, NJ
08505. Postage due and freight collect items will
not be accepted.
Battery Installation
See Battery Installation Diagram
• (2) CR2016 Coin Cells - 6V
Princeton Tec cares about the environment and
recommends recycling batteries. For more
information about battery recycling, please go to:
www.batteryrecycling.com
To install the batteries, rotate light unit out of hat
clip. Lift tab of battery door on the underside of
light unit to expose coin cell
Install coin cell batteries with the positive + side
facing up. Improper installation of the batteries will
damage the light and void the warranty.
Replace the battery door with the lift tab properly
aligned with lift tab slot of the housing. Press
door firmly in place making sure it is all the way
seated in place.
WARNING
Never mix fresh and used batteries. Never mix
different battery brands or chemistry types.
Always remove drained batteries immediately.
Remove batteries during long periods of storage.
Hat Clip Mounting
The Hat-Clip Point light unit can be mounted to
the clip either of two ways, depending on how
you will be using the light. Once you have oriented
the light unit and hat clip appropriately, simply
insert the light unit tabs into the hat clip slots and
rotate the light unit clockwise until it locks into
position.
Your Hat-Clip Point light is designed to clip to a hat
brim, shirt pocket or collar, a piece of webbing, fishing
vest etc.
Switch Operation
Modes (Low then High) are selected by pressing
and releasing the button within 1.6 seconds of the
previous button press.
There are three ways to turn the Hat Clip Point off.
1. You can cycle through the modes within 1.6
seconds of the initial button press until you reach off.
2. Or if more than 1.6 seconds has passed since
the previous button press the next press of
the button will turn the light off.
3. Or when turning the light on, press and hold
the button for momentary light output (in Low
mode) and after 1.6 seconds has passed,
releasing the button will turn the light off.
Troubleshooting
If the If Hat-Clip Point fails to light:
• Check the batteries for proper installation.
• If proper installation is
confirmed replace batteries.
• This light has been designed to be water
2011