beautypg.com

Princeton Tec VIZZ INDUSTRIAL User Manual

Vizz, Indus trial, English

background image

VIZZ

TM

INDUS

TRIAL

LED HEADLAMP

ENGLISH

Battery Installation - See Figure 1

3 AAA

• Alkaline (LR03)

• Lithium (L92)

• Rechargeable NiCad or NiMH

Princeton Tec cares about the environment

and recommends recycling batteries. For

more information about battery recycling,

please go

to www.batteryrecycling.com.

Observe proper battery polarity. Improper

installation of the batteries will damage the

light and void the warranty.

WARNING

• Never mix fresh and used batteries.

• Never mix different battery brands or

chemistry types.

• Always remove drained batteries

immediately.

• Remove batteries during long periods of

storage.

NOTE: Lithium batteries offer extended con-

stant brightness time, extreme cold weather

performance, and lighter weight. Rechargeable

NiCad or NiMH batteries may result in reduced

brightness due to lower nominal voltage.

The Vizz battery compartment has a wa-

terproof seal. It is important to keep this

seal free from dirt and away from harsh

chemicals in order to preserve waterproof

integrity. Inspect the seal every time batteries

are changed. If dirt is present, wipe gently

with a damp cotton swab and mild soap until

dirt is removed.

Switch Operation -

See Figure 2

A single press turns on Maxbright (spot)
mode. Ultrabright (flood) mode is selected
by holding button. Ultrabright mode starts at
the highest highest intensity level; intensity
decreases until button is released. If button
is held down continuously, light intensity will
scroll down and back up until button is re-
leased. If another brightness is desired after
button has been released, holding button will
resume scrolling through Ultrabright LED
intensity levels.
A single press more than two seconds after the
previous button press will turn the light off.

Troubleshooting

If the Vizz fails to light:

• Check the batteries for proper installation.

• Replace batteries if proper installation is

confirmed.

• Check circuit board for water (the seal may

have been compromised by improper rear

cover installation or dirty seal). The light will

resume normal operation once the water

is shaken or blown out and the light is left

open until completely dry. If the light has

been contaminated with salt water, flush

the unit with fresh water and dry as

described above.

USA Lifetime Warranty - International
10-YearWarranty

Due to International regulations, Princeton

Tec’s lifetime warranty can only be offered to

customers in the USA. Princeton Tec offers a

10-year warranty to our customers outside

the USA. FULL WARRANTY - Princeton Tec

warrants this product to be free from defects

in workmanship and materials under normal

use for as long as you own this product. This

warranty covers all of the component parts

of the product except batteries. This warranty

does not cover deterioration due to normal

wear or damage due to misuse, alteration,

negligence, accidents, or unauthorized repair.

Princeton Tec will repair or replace parts which

are defective In workmanship or materials.

Your authorized Princeton Tec Dealer and

Princeton Tec are the only facilities authorized

to repair the product. After (3) unsuccessful

attempts to repair the product, you have the

right to elect replacement of the product or a

refund of the purchase price less allowance

for use of the product. NO INCIDENTAL OR

CONSEQUENTIAL DAMAGES ARE INCLUDED

IN THIS WARRANTY. (Some states do not al-

low the exclusion or limitation of incidental or

consequential damages, so the above limita-

tions or exclusions may not apply to you.)

This warranty gives you specific legal rights,

and you may also have other rights which

vary from state to state.

Princeton Tec reserves the right to change

product specifications without notice.

Return Policy

If your light fails to operate, follow these

simple steps:

1) Check batteries. Replace if necessary.

2) Contact Princeton Tec customer service at

800-257-9080 to request an RMA number in

order to send your light for repair or replace-

ment. No warranties will be accepted without

an RMA number.

3) If the light continues to function improp-

erly, return it without batteries to: Princeton

Tec, 5198 Rt. 130 Bordentown, NJ 08505.

Postage due and freight collect items will not

be accepted.

Princeton Tec

PO Box 8057,

Trenton, NJ 08650

Phone: 609-298-9331

Fax: 609-298-9601

© 2013 Princeton Tec

Figure 2 – Switch Operation

Modes de fonctionnement

Schalterbetätigung

MAXBRIGHT LED

ULTRABRIGHT WHITE

DIMMABLE LEDs

39

90

Princeton Tec calculates total burn time as the time it takes for the light source to produce a minimum of

0.25 lux at 2 meters. 0.25 lux is about the equivalent of a full moon on a clear night.

Princeton Tec berechnet die Gesamtbrenndauer bezogen auf eine von der Stirnlampe erzeugte minimale

Beleuchtungsstärke von 0,25 Lux in 2 Meter Abstand. 0,25 Lux entsprechen in etwa der Beleuch-

tungsstärke des Vollmonds in einer klaren Nacht.

Princeton Tec définit la durée totale d’éclairage comme le temps nécessaire à la source

lumineuse pour produire un minimum de 0,25 lux à 2 mètres. 0,25 lux équivaut à peu près à la

luminosité d’une pleine lune dans un ciel nocturne dégagé.

Figure 1 – Battery Replacement

Remplacement des piles

Batteriewechsel

1

2

3

4

www.princetontec.com

SINGLE PRESS

MAXBRIGHT LED

SINGLE PRESS

TURNS LIGHT OFF

HOLD

WHITE ULTRABRIGHT

(HIGH) (LOW)