Princeton Tec ECO FLARE - Manual

OPERATING AND
MAINTENANCE
INSTRUCTIONS
LIFETIME WARRANTY
FULL WARRANTY - Princeton Tec warrants this product
to be free from defects in workmanship and materials
under normal use for as long as you own this product.
This warranty covers all of the component parts of the
product except bulbs, harness and batteries. This
warranty does not cover deterioration due to normal
wear or damage due to misuse, alteration, negligence,
accidents or unauthorized repair. Princeton Tec will
repair or replace parts which are defective in
workmanship or materials.
Your Authorized Princeton Tec Dealer and Princeton
Tec are the only facilities authorized to repair the
product. After (3) unsuccessful attempts to repair the
product, you have the right to elect replacement of the
product or a refund of the purchase price less allowance
for use of the product. NO INCIDENTAL OR
CONSEQUENTIAL DAMAGES ARE INCLUDED IN THIS
WARRANTY. (Some states do not allow the exclusion or
limitation of incidental or consequential damages, so the
above limitations or exclusions may not apply to you.)
This warranty gives you specific legal rights, and you may
also have other rights which vary from state to state.
Princeton Tec reserves the right to change product specifications without notice.
RETURN POLICY
PO BOX 8057 TRENTON, NJ 08650
609-298-9331 609-298-9601 FAX
©2008 PRINCETON TEC
BATTERIES - For best performance, use alkaline
AAA-cells. IMPORTANT - Remove batteries during
long periods of storage. Remove exhausted batteries
from light immediately.
BULB/L.E.D. REPLACEMENT - Use only Princeton
Tec genuine replacement bulbs. To access the bulb,
unscrew the cone and remove the reflector assembly.
Pull bulb out and replace– see diagram. The L.E.D. is
a diode and therefore requires proper polarity to
function. If the unit fails to operate, rotate the reflector
assembly 180∞.
O-RING - Occasionally clean and lightly lubricate the
O-ring and Lens Cap threads. Use only silicone
grease, never use aerosol spray lubricants.
WARNING - All plastic components are made of
high-impact resistant polycarbonate plastic. Certain
forms of aerosol sprays can cause damage and
void warranty.
MAINTENANCE - As with any outdoor equipment, the
light should be kept clean with soap and water. Avoid
getting dirt in the threads of the cone. If this should
occur, take the light apart, remove the batteries and
clean the light with soap and water, lubricate
o-ring and reassemble the light.
NOTE - Some battery formulations can emit hydrogen
gas. This gas can create an explosion potential in
sealed devices, if it is not vented or removed. The
platinum catalyst in this light will remove the gas.
O-RING
SPRING
AAA BATTERIES
REFLECTOR
ASSEMBLY
LED LENS
If your light fails to operate, follow these simple steps:
1) Check batteries. Replace if necessary.
2) Contact Princeton Tec customer service at
800-257-9080 to request an RMA# in order to send
your light for repair or replacement. No warranties will
be accepted without an RMA#.
3) If the light continues to function improperly, return it
without batteries to: Princeton Tec, 5198 Rt. 130
Bordentown, NJ 08505. Postage due and freight
collect items will not be accepted