Princeton Tec VIZZ User Manual

Vizz, English

VIZZ

LED HEADLAMP

ENGLISH

Battery Installation - See Figure 1

3 AAA

• Alkaline (LR03)

• Lithium (L92)

• Rechargeable NiCad or NiMH

Princeton Tec cares about the environment

and recommends recycling batteries. For

more information about battery recycling,

please go

to www.batteryrecycling.com.

Observe proper battery polarity. Improper

installation of the batteries will damage the

light and void the warranty.

WARNING

• Never mix fresh and used batteries.

• Never mix different battery brands or

chemistry types.

• Always remove drained batteries

immediately.

• Remove batteries during long periods of

storage.

NOTE: Lithium batteries offer extended con-

stant brightness time, extreme cold weather

performance, and lighter weight. Rechargeable

NiCad or NiMH batteries may result in reduced

brightness due to lower nominal voltage.

The Vizz battery compartment has a wa-

terproof seal. It is important to keep this

seal free from dirt and away from harsh

chemicals in order to preserve waterproof

integrity. Inspect the seal every time batteries

are changed. If dirt is present, wipe gently

with a damp cotton swab and mild soap until

dirt is removed.

Switch Operation -

See Figure 2

Ultrabright Red and Maxbright White modes

are selected via short button presses. Single

press turns on Ultrabright Red. Double press

turns on Maxbright White. Ultrabright White

mode is selected by holding button. Ultra-

bright White mode starts at lowest bright-

ness level; intensity increases until button is

released. If button is held continuously, light

intensity will scroll up and down until button

is released. If another brightness is desired

after button has been released, holding but-

ton will resume scrolling through Ultrabright

intensity levels.

A single press more than two seconds after

the previous button press will turn light off.

From off state, triple press will lock light to

prevent accidental turn on and resulting bat-

tery drain.The Indicator LED (located inside

the power button) will blink three times to

confi rm lock.Triple press from the locked

state will unlock the light and the indicator

LED will fl ash to confi rm unlock. Removal and

replacement of batteries will also reset Vizz to

unlocked state.

Troubleshooting

If the Vizz fails to light:

• Check the batteries for proper installation.

• Replace batteries if proper installation is

confi rmed.

• Check circuit board for water (the seal may

have been compromised by improper rear

cover installation or dirty seal). The light will

resume normal operation once the water

is shaken or blown out and the light is left

open until completely dry. If the light has

been contaminated with salt water, fl ush

the unit with fresh water and dry as

described above.

Low Battery Indicator

The Low Battery Indicator is a red LED located

inside the power button. When Vizz is turned off

with approximately 20% of battery power re-

maining, this indicator LED will fl ash for around

12 hours. NOTE: The indicator LED only fl ashes

when headlamp is turned off, and will not blink

while headlamp is turned on. Flashing ceases

when the headlamp is locked out.

USA Lifetime Warranty - International
10-YearWarranty

Due to International regulations, Princeton

Tec’s lifetime warranty can only be offered to

customers in the USA. Princeton Tec offers a

10-year warranty to our customers outside

the USA. FULL WARRANTY - Princeton Tec

warrants this product to be free from defects

in workmanship and materials under normal

use for as long as you own this product. This

warranty covers all of the component parts

of the product except batteries. This warranty

does not cover deterioration due to normal

wear or damage due to misuse, alteration,

negligence, accidents, or unauthorized repair.

Princeton Tec will repair or replace parts

which are defective In workmanship or mate-

rials. Your authorized Princeton Tec Dealer and

Princeton Tec are the only facilities authorized

to repair the product. After (3) unsuccessful

attempts to repair the product, you have the

right to elect replacement of the product or a

refund of the purchase price less allowance

for use of the product. NO INCIDENTAL OR

CONSEQUENTIAL DAMAGES ARE INCLUDED

IN THIS WARRANTY. (Some states do not

allow the exclusion or limitation of incidental

or consequential damages, so the above limi-

tations or exclusions may not apply to you.)

This warranty gives you specifi c legal rights,

and you may also have other rights which

vary from state to state.

Princeton Tec reserves the right to change

product specifi cations without notice.

Return Policy

If your light fails to operate, follow these

simple steps:

1) Check batteries. Replace if necessary.

2) Contact Princeton Tec customer service at

800-257-9080 to request an RMA number in

order to send your light for repair or replace-

ment. No warranties will be accepted without

an RMA number.

3) If the light continues to function improp-

erly, return it without batteries to: Princeton

Tec, 5198 Rt. 130 Bordentown, NJ 08505.

Postage due and freight collect items will not

be accepted.

Princeton Tec

PO Box 8057,

Trenton, NJ 08650

Phone: 609-298-9331

Fax: 609-298-9601

Figure 2 – Switch Operation

Modes de fonctionnement

Schalterbetätigung

160H

MAXBRIGHT LED

110H

150H

ULTRABRIGHT WHITE

DIMMABLE LEDs

ULTRABRIGHT RED LEDs

•

Princeton Tec calculates total burn time as the time it takes for the light source to produce a minimum of

0.25 lux at 2 meters. 0.25 lux is about the equivalent of a full moon on a clear night.

•

Princeton Tec berechnet die Gesamtbrenndauer bezogen auf eine von der Stirnlampe erzeugte minimale

Beleuchtungsstärke von 0,25 Lux in 2 Meter Abstand. 0,25 Lux entsprechen in etwa der Beleuch-

tungsstärke des Vollmonds in einer klaren Nacht.

•

Princeton Tec déﬁ nit la durée totale d’éclairage comme le temps nécessaire à la source

lumineuse pour produire un minimum de 0,25 lux à 2 mètres. 0,25 lux équivaut à peu près à la

luminosité d’une pleine lune dans un ciel nocturne dégagé.

Figure 1 – Battery Replacement

Remplacement des piles

Batteriewechsel

www.princetontec.com

SINGLE PRESS

RED ULTRABRIGHT LEDs

DOUBLE PRESS

MAXBRIGHT LED

SINGLE PRESS

TURNS LIGHT OFF

TRIPLE PRESS

LOCK OUT

HOLD

WHITE ULTRABRIGHT LEDs

(LOW) (HIGH)