Princeton Tec AMP 1L W/ BOTTLE OPENER & CONE - Manual

AMP 1.L ™
LED FLASHLIGHT
www.princetontec.com
Operating and Maintenance Instructions
Notice d’utilisation et d’entretien
Bedienungs- und Pflegeanleitung
• Princeton Tec calcule le temps d'illumination total comme étant la durée
écoulée avant que la torche ne produise un minimum de 0,25 lux à 2
mètres. 0,25 lux est à peu près l'équivalent de la pleine lune par une
nuit au ciel dégagé.
• Princeton Tec berechnet die Gesamtleuchtdauer als die Zeit, in der
die Lichtquelle eine Mindesthelligkeit von 0,25 Lux in zwei Metern
Entfernung produziert. 0,25 Lux entsprechen dem Licht des Vollmonds
in einer klaren Nacht.
• Princeton Tec calculates total burn time as the time it takes for the light
source to produce a minimum of 0.25 lux at 2 meters. 0.25 lux is about
the equivalent of a full moon on a clear night
26 39 58
1 Maxbright
LED
turn = ON
PO Box 8057
Trenton, NJ 08650
Phone: 609-298-9331
Fax: 609-298-9601
www.princetontec.com
© 2013 Princeton Tec
72H
Battery Installation
See Battery Installation Diagram
• 2 AAA
• Alkaline (LR03)
• Rechargeable NiCad or NiMH
IMPORTANT:
Remove batteries during long periods of
storage. Remove exhausted batteries from
light immediately.
O-Ring
Occasionally clean and lightly lubricate the
O-ring and Lens Cap threads. Use only
silicone grease, never use aerosol spray
lubricants.
Warning
All plastic components are made of
High-Impact resistant polycarbonate
plastic.
Certain forms of aerosol sprays can cause
damage and void warranty.
NOTE: Some battery formulations can emit
hydrogen gas. This gas can create an
explosion potential in sealed devices, if it is
not vented or removed. The Amp 1L is
equipped with a platinum catalyst to
remove this gas.
Maintenance
As with any outdoor equipment, the light
should be kept clean with soap and water.
Avoid getting dirt in the threads of the lens
cap. If this should occur, take the light
apart, remove the batteries and clean the
light with soap and water, lubricate o-ring
and reassemble the light.
Troubleshooting
If the Amp 1L fails to light:
• Check the batteries for proper installation.
• Replace batteries if proper installation is
confirmed.
• Check the inside of the light for water.
(the seal may have been compromised)
The light will resume normal operation
once the water is shaken or blown out
and the light is left open until completely
dry. If the light has been contaminated
with salt water, flush the unit with fresh
water and dry as described above.
USA Lifetime Warranty- International
10-year Warranty
Due to International regulations, Princeton
Tec’s lifetime warranty can only be offered
to customers in the USA. Princeton Tec
offers a 10-year warranty to our customers
outside the USA.
FULL WARRANTY - Princeton Tec warrants
this product to be free from defects in
workmanship and materials under normal
use for as long as you own this product.
This warranty covers all of the component
parts of the product except bulbs and
batteries. This warranty does not cover
deterioration due to normal wear or
damage due to misuse, alteration,
negligence, accidents or unauthorized
repair. Princeton Tec will repair or replace
parts which are defective in workmanship
or materials.
Your Authorized Princeton Tec Dealer and
Princeton Tec are the only facilities
authorized to repair the product. After (3)
unsuccessful attempts to repair the
product, you have the right to elect
replacement of the product or a refund of
the purchase price less allowance for use
of the product.
NO INCIDENTAL OR CONSEQUENTIAL
DAMAGES ARE INCLUDED IN THIS
WARRANTY. (Some states do not allow the
exclusion or limitation of incidental or
consequential damages, so the above
limitations or exclusions may not apply to
you.) This warranty gives you specific legal
rights, and you may also have other rights
which vary from state to state.
Princeton Tec reserves the right to change
product specifications without notice
Return Policy
If your light fails to operate, follow these
simple steps:
1) Check the batteries. Replace if necessary.
2) Contact Princeton Tec customer service
at 800-257-9080 to request an RMA# in
order to send in your light for repair or
replacement. No warranties will be
accepted without an RMA#.
Bottle opener Embouteiller l'ouvre-boîtes Flaschenöffner