MagTek 99875125 - Manual (Page 89)

Appendix A. Installation and Setup
Installing MiniMICR:
Set MiniMICR to 1 under the “INSTALL” section. If you have selected to install the MiniMICR driver
then change the device settings under the “MiniMICR” section.
If the MiniMICR is a RS-232 device then change the values of PortName, UsePort, baud, datasize,
stopbits, and parity.
Example:
[MiniMICR]
DEVICE=MiniMICR
FriendlyName=MiniMICR
PortName=COM8:
UsePort=COM1:
baud=9600
datasize=7
stopbits=1
parity=EVEN
If the MiniMICR is a USB device then change the value of PortName, UsePort. Set the UsePort to “USB:”
Example:
[MiniMICR]
DEVICE=MiniMICR
FriendlyName=MiniMICR
PortName=COM8:
UsePort=USB:
If the MiniMICR is a wedge device then change the values of PortName and UsePort. Set the UsePort to
“KB:”
Example:
[MiniMICR]
DEVICE=MiniMICR
FriendlyName=MiniMICR
PortName=COM8:
UsePort=KB:
81