Help – Kenwood DNX9260BT User Manual
Page 107
DDX series DDX8026BT English
107
Help?
Troubleshooting
Some functions of this unit may be disabled
by some settings made on this unit.
!
• Cannot set up the subwoofer.
• Cannot set up subwoofer phase.
• No output from the subwoofer.
• Cannot set up the low pass filter.
• Cannot set up the high pass filter.
▲
Subwoofer is not set to On.
☞
▲
The Dual zone function is enabled.
☞
!
• Cannot select the output destination of
the subsource in the Dual zone.
• Cannot adjust the volume of the rear
speakers.
▲
The Dual zone function is disabled.
☞
!
Cannot play audio files.
▲
"CD Read" of
"2".
!
Cannot Folder select.
▲
The Random play function is enabled.
!
Cannot perform Repeat play.
▲
The PBC function of the Video CD is
enabled.
!
• Cannot set up the equalizer.
• Cannot set up the crossover network.
▲
The Dual zone function is enabled.
☞
▲
The DSP Select is Bypass.
☞
What might seem to be a malfunction in
your unit may just be the result of slight
misoperation or miswiring. Before calling
service, first check the following table for
possible problems.
General
?
The Touch Sensor Tone doesn’t sound.
✔
The preout jack is being used.
☞
The Touch Sensor Tone can’t be output from
the preout jack.
Tuner source
?
Radio reception is poor.
✔
The car antenna is not extended.
☞
Pull the antenna out all the way.
✔
The antenna control wire is not connected.
☞
Connect the wire correctly, referring to the
section on
Disc source
?
The specified disc does not play, but
another one plays instead.
✔
The specified CD is quite dirty.
☞
Clean the CD.
✔
The disc is severely scratched.
☞
Try another disc instead.
Audio file source
?
The sound skips when an Audio file is
being played.
✔
The media is scratched or dirty.
☞
Clean the media, referring to the CD
cleaning of the section on
(page 4).
✔
The recording condition is bad.
☞
Record the media again or use another
media.
B64-4676-00_01_E_English.indd 107
B64-4676-00_01_E_English.indd 107
10/02/05 15:27
10/02/05 15:27