Kenwood KMR-700U - Manual (Page 4)

4 | KMR-700U
Getting Started
C C C Co Co Co Co Co nn nnec i ti ti ti ng i i i i P P Po d d d d or U U U S SB SB SB d d d d ev i i i ic e
1 1 1 1 Press the Release button.
Release button
Pull the faceplate open, while supporting it with
your hand.
2 2 2 2 Remove the terminal cover.
Terminal cover
3 3 3 3 Pull out the terminal to be used, and then
replace the terminal cover.
4 4 4 4 Connect iPod and USB device to the terminal.
5 5 5 5 Insert the connected iPod and USB device into
the cushion bag (accessory), and place it on
the terminal cover.
Cushion bag
⁄ ⁄ ⁄ ⁄ ⁄
• Be sure to use the cushion bag which protects iPod o r
USB device against shock.
• Do not overload the opened faceplate. If you do so,
the faceplate may be damaged.
6 Close the faceplate.
Removing iPod or USB device
1 Enter Remove mode
Press the [iPod] button for at least 2 second.
“REMOVE” is displayed.
2 Select the device to be removed
Select the device to be removed by turning
the [VOL] knob, and press the [ENTER] button
. . .
3 Turn the [VOL] knob to select “YES”, and then
press the [ENTER] button.
4 Press the Release button.
Pull the faceplate open, while supporting it with
your hand.
5 Remove the device.
Only the device selected in step 2 can be
removed.
⁄
• Keep the unused terminal in the terminal cover to
avoid being damaged.
Cancelling the Remove mode
Press the [iPod] button for at least 1 second.
B64-4406-00_00_KMR-700U_K_en.indd 4 B64-4406-00_00_KMR-700U_K_en.indd 4 09.2.16 11:00:02 AM 09.2.16 11:00:02 AM