beautypg.com

References – Kenwood DDX4025BT User Manual

Page 58

background image

58

Error message list

If an error occurs while using the unit, a message

appears. Take appropriate action according to the

following message/remedy/cause list.
“No Signal”:

• Start the playback on the external component

connected to the AV-IN1 or iPod/AV-IN2 input

terminal.

• Check the cords and connections.

• Signal input is too weak.
“Miswiring DC Offset Error ”/“Warning DC Offset

Error ”:

• A speaker cord has shorted or it has come in to

contact with the car chassis. Wire or insulate the

speaker cord as appropriate, then reset the unit.

(Pages 3 and  51)

“ Parking off”:

• No playback picture is shown when the parking

brake is not engaged.

“ Authorization Error”:

• Check whether the connected iPod/iPhone is

compatible with this unit. (Page 56)

“USB Device Error”:

• The USB power voltage is abnormal.

• Turn off and turn on the unit.

• Connect another USB device.

“No Navigation”:

• No navigation unit is connected.
“Connection Error”:

• The device is registered but the connection has

failed. Connect the registered device. (Page 30)

“Please Wait...”:

• The unit is preparing to use the Bluetooth

function. If the message does not disappear, turn

off and turn on the unit, then connect the device

again (or reset the unit).

“No Voice Device”:

• The connected mobile phone does not have a

voice recognition system.

“No Data”:

• No phone book data is contained in the connected

Bluetooth phone.

“Initialize Error”:

• The unit has failed to initialize the Bluetooth

module. Try the operation again.

“Dial Error”:

• Dialing has failed. Try the operation again.
“Hung Up Error”:

• The call has not ended yet. Park your car, and use

the connected mobile phone to end the call.

“Pick Up Error”:

• The unit has failed to receive a call.
“Antenna Error”:

• The antenna has a short-circuit and the protective

circuit has activated.

• Check the Digital Radio antenna. If a passive

antenna without a booster is used, set Antenna

power “OFF”.

REFERENCES

REFERENCES

DDX_Entry_E.indb 58

DDX_Entry_E.indb 58

2013/10/30 13:54

2013/10/30 13:54

This manual is related to the following products: