Kenwood KRF-V5450D - Manual (Page 39)

English
39
Sound ad
ju
st
men
t
The audio can be adjusted as desired according to the source
being played.
SOUND
MULTI CONTROL
O/
MULTI CONTROL SOUND
1
Press [SOUND] to enter the surround adjustment
mode.
Each press switches the mode as follows.
Note that some items are not displayed depending on
speaker settings and listen mode.
Display Setting item Range
"C" Center speaker level -10 – +10dB
*1
"RS" Surround Right speaker level -10 – +10dB
"BS" Surround Back speaker level -10 – +10dB
"LS" Surround Left speaker level -10 – +10dB
"SW" Subwoofer level -10 – +10dB
"INPUT" Input level -6, -3, 0 *2
"NIGHT" Midnight mode "ON", "OFF" *3
"PANORAMA" Panorama mode "ON", "OFF"
*4 "DIMENSION" Dimension
"CENTER WIDTH" Center Width
"CENTER IMAGE" Center Image 0.0 – 1.0 *5
Input source
name
Exit the adjustment mode.
* 1 The adjustment is only temporary for the current input
selection. The value will return automatically to the original
setup value when the power is turned on/off or when the
input selection is changed.
* 2 Analog source only
* 3 Dolby Digital and DTS mode only
* 4 Pro Logic II Music mode and Pro Logic IIx Music mode only
* 5 Neo:6 Music mode only
2
Use [MULTI CONTROL
∞/5] to adjust the desired
item.
For detailed adjustment method, see the explanation of
each item.
To exit the sound adjustment mode
Press [SOUND].
Speaker level adjustment Speaker level adjustment
The output level from the desired speaker channels can be fine
adjusted according to the properties of each source.
The adjustment is only temporary for the current input selection.
The value will return automatically to the original setup value
when the power is turned on/off or when the input selection is
changed.
1
Press [SOUND] repeatedly to select the speaker to
adjust ("C", "RS", "BS", "LS" or "SW").
2
Use [MULTI CONTROL
∞/5] to adjust the level.
3
Repeat steps 1 and 2 to adjust the level of other
speakers.
Input level adjustment Input level adjustment
¶ Analog source only
If the input level of an analog source signal is too high, the CLIP
indicator will light to indicate. Adjust the input level.
1
Press [SOUND] repeatedly to select "INPUT".
2
Use [MULTI CONTROL ∞/5] to adjust the input
level.
Adjustments according to the playing source
B60-5810-08_00_EN.indd 39 B60-5810-08_00_EN.indd 39 09.7.24 9:05:28 AM 09.7.24 9:05:28 AM