Preparation of remote control, Installation, Preparing the remote control unit – Kenwood K-511USB-B User Manual
Page 6: Installation precautions
Left speaker
Right speaker
Main unit
10
K-511USB/RD-K511USB
11
English
Loading batteries
1Remove the battery cover.
2Insert the provided AAA-
size batteries.
Insert batteries with correct
polarity.
•
3Close the battery cover.
The provided batteries are intended for use in operation
check and their service life may be shorter than usual.
When replacing batteries, be always sure to replace both
of the two batteries together.
•
•
Operation
Plug the power cord of the system to a power outlet
and press [
K] on the remote control unit to turn the
system ON. After the system is switched ON, press the
desired operation button. Use the remote control unit
by pointing it to the remote sensor on the main unit.
About
6 m
About 30°
About 30°
The system may malfunction if the remote control sensor
is exposed to direct sunlight or the light of a fl uorescent
lamp with high-frequency lighting system (inverter
system, etc.). Change the system installation to prevent
malfunction.
•
Preparing the remote control unit
Preparation of remote control
Installation precautions
Always install the system on a level, stable surface. When installing on a stand or tabletop, be sure to confi rm the strength of the stand.
The magnetism from the speakers may cause color irregularities on a nearby TV or PC screen. Always install the speakers at
a distance from a TV or PC.
•
•
Installation
Observe the following cautions when installing the system. Insuffi
cient heat
radiation may build up internal heat and cause a malfunction or fi re hazard.
Do not place an object that may hinder heat radiation on the system.
Do not install the system on the back, on the side or upside down.
Do not place a cloth on the system or place it on a carpet or cushion.
Do not use the system in a poorly ventilated place.
Leave the spaces specifi ed below around the cabinets of the main unit.
Top: 50 cm or more, Side: 10 cm or more, Rear: 10 cm or more
Install the system so that the power outlet is easily accessible from the user, and
unplug the power cord from the power outlet immediately in case of a trouble.
Note that the power supply to the system is not shut down completely by simply
setting the power button to OFF. To shut down the power supply completely, it is
required to unplug the power cord.
•
•
•
•
•
To fully enjoy the acoustic eff ects
The audio is variable depending on how the speakers are installed. Ensure the following points to enjoy music with
higher quality.
Make the environments around the left and right speakers as equal as possible. Install the left and right speakers at a
distance of a wall, and minimize the sound reverberations by drawing thick curtains on the windows.
Place the left and right speakers at a large distance between each other.
Place the left and right speakers on the same height as the ears of the listener.
•
•
•
Read bef
or
e use
The speakers is not provided with
RD-K511USB.
¤
CAUTION
• Do not leave the battery near fire or under direct
sunlight. A fire, explosion or excessive heat generation
may result.
CAUTION