Kenwood K-511USB-B - Manual (Page 22)

ENTER
DISPLAY/
CHARAC.
AUX
42 K-511USB/RD-K511USB 43 English
Playback with the AUX Connection
An external component can be connected to the
system for playback as the AUX audio source.
Playback
1
Connect an external component.
Connect the [AUX IN] terminals on the rear of
the system to the audio outputs of the external
component.
VCR, etc.
Also read the instruction manual for the connected
auxiliary component.
Be sure to turn both this system and the external
component OFF before connecting them.
2
Set the audio source.
Press [AUX].
3
Turn the connected external
component ON and start playing it.
If the audio level of the connected external component
is lower or higher than the level at the same volume
control position of other audio sources, adjust the input
level of this system. For how to adjust the input level, see
page 69.
•
•
•
Switching the mode
The playback with the AUX connection can be
switched between the following two modes.
AUX: Use this mode when the connected component
outputs audio only.
AUX (BYPASS MODE): Use this mode when the connected
player outputs both audio and video, for example it is
a VCR. In this mode, the audio signal is output without
passing through the DSP (Digital Signal Processor) so that
it will not be delayed with respect to the played video.
Note that recording in SD/USB is not possible in BYPASS
MODE.
1
Switching the mode
Press [ENTER].
Each press switches the mode.
Select "BYPASS MODE".
Operation in BYPASS MODE
The system cannot set the audio settings other than
the TONE setting.
The record button of the system is defeated.
The mode setting is held even after the audio source
is switched or the system is turned OFF.
•
•
•
•
•
Pla
ying music tracks