Kenwood K-511USB-B - Manual (Page 38)

ENTER
RETURN
STOP F
SETUP
SLEEP DIMMER
MULTI CONTROL
74 K-511USB/RD-K511USB 75 English
Setting the Sleep Timer (SLEEP)
During or before playing an audio source, the sleep
timer can be set to end the play after the set period
of time and turn the system OFF automatically.
1
Select "SLEEP".
Press [MULTI CONTROL A/B]
to select, then press [ENTER].
2
Setting the Sleep Timer
Press [MULTI CONTROL A/B]
to select, then press [ENTER].
Each press switches the selection.
10
20
30
40
50
Select "OFF" to cancel.
OFF
90
80
70
60
The sleep timer
operation indicator
lights on the display.
To check the remaining period of the sleep
timer after setting:
Press [SLEEP].
The remaining sleep
timer period is displayed
for 5 seconds.
Pressing the button again makes it possible to add
a new sleep timer period to the current remaining
period.
■
•
The display brightness cannot be adjusted when the
system status is one of the following:
In standby mode
Immediately after power ON
During power OFF processing
During setting using [SETUP]/[TOOL]
To set using [DIMMER] of the remote control unit
Press [DIMMER].
Each press switches the brightness.
Formatting an SD card (SD
FORMAT)
This system can be used to format an SD card. Formatting
an SD card erases all of the data recorded in it.
1
Select "SD FORMAT".
Press [MULTI CONTROL A/B]
to select, then press [ENTER].
2
Select the SD card to be formatted.
Press [MULTI CONTROL A/B]
to select, then press [ENTER].
Each press switches the selection.
SD1 FORMAT
SD2 FORMAT
RETURN
The display returns to the
"SYSTEM SETUP" display.
•
•
•
•
The sleep timer cannot be set when the system status is
one of the following:
In standby mode
During power OFF processing
During clock/program timer setting
During setting using [SETUP]/[TOOL]
To set using [SLEEP] of the remote control unit
Press [SLEEP].
Each press switches the timer.
Adjusting the Display Brightness
(DIMMER SET)
The brightness of the display panel can be adjusted
and the illumination can be switched ON/OFF.
1
Select "DIMMER SET".
Press [MULTI CONTROL A/B]
to select, then press [ENTER].
2
Adjust the display brightness and
illumination.
Press [MULTI CONTROL A/B]
to select, then press [ENTER].
Each press switches the selection.
DIMMER OFF
DIMMER 1
DIMMER 2
DIMMER 3
Low display brightness,
illumination ON
High display brightness,
illumination ON
Low display brightness,
illumination OFF
High display brightness,
illumination OFF
•
•
•
•
A
d
vanc
ed oper
ations
continued on next page
Making the system setup using the Setup menu