Siemens TE502206RW - Manual (Page 25)

21
de en
Problem Cause Solution
Display shows
Error
Call hotline
The appliance has a fault. Please call the hotline�
The water filter does not
stay in position in the water
tank (16)�
The water filter is not
mounted correctly.
Firmly press the water filter
straight down into the tank
connection�
The coffee grounds are not
compact and are too wet�
The grinding setting is
too fine or too coarse, or
not enough ground coffee
has been used.
Adjust the grinding unit to a
coarser or finer setting, or use
2 level measuring spoons of
ground coffee.
Display shows
Clean brewing unit
Brewing unit (5) is soiled� Clean brewing unit (5)�
Too much pre-ground
coffee in the brewing
unit (5)�
Clean brewing unit (5)�
Pour in no more than 2 level
measuring spoons of ground
coffee�
The brewing unit’s
mechanism is stiff�
Remove and clean the brewing
unit, see “Maintenance and daily
cleaning”�
Coffee or milk froth quality
varies considerably�
Build-up of limescale in
the appliance�
Descale the appliance with two
descaling tablets as described in
the instructions.
Water dripped onto the
inner floor of the appliance
when the drip tray (8) was
removed�
Drip tray (8) removed too
early�
Wait a few seconds after the
last drink was dispensed before
removing the drip tray (8)�
Display shows
Insert brewing unit
Brewing unit (5) is
missing or was not
recognised�
Switch off the appliance with the
brewing unit (5) in place, wait
three seconds and switch on the
appliance�
Restore the unit to its
original factory settings
(“Reset”)�
You changed some
settings and want to
discard them�
Turn off the unit with the power
on/off switch O / I (9)� Press
and hold the
e
off / j (12) and
the h (11) button and turn the
appliance on with the power on/
off switch O / I (9). Confirm by
pressing the start button start
(10). The factory settings are
now activated�
If you are unable to solve the problem, please call the hotline.