Siemens TE502206RW - Manual (Page 13)

9
de en
Menu settings
You can adapt the appliance to your
individual needs in the menu settings.
1� Hold the
e
off / j button (12) down for at
least 3 seconds�
2� Press the
e
off / j button (12) repeatedly
until the required menu item appears in
the display�
3� Select the required setting with the
upper rotary knob (14).
4� Confirm by pressing the start button
(10)�
To leave the menu without making any
changes, turn the rotary selector to Exit
and press the start button (10).
You can set the following:
Shut off
Here you can set the time span after which
the appliance automatically switches off
following the last drink preparation� A time
between 15 minutes and 4 hours can be
set. The default time is 1 hour, but this can
be shortened to save energy�
Filter
Here you can set whether a water filter is
being used. If a water filter is not being
used, turn the setting to No / Old � If a
water filter is being used, turn the setting to
Activate filter . New water filters have to
be rinsed before use (see “Water filter” on
page 8)�
Start Calc‘n‘Clean
The service programmes ( Calc‘n‘Clean
/ descaling / cleaning ) can be selected
manually here. Press the start button (10)
and run the selected programme (see “Ser-
vice Programmes” on page 15)�
Temp.
The brewing temperature ( high / middle /
low ) can be set here�
Language
The display language can be set here.
Water hardness
The water hardness setting can be adjusted
on this appliance� It is important to set the
water hardness correctly, so that the appli-
ance indicates accurately when the descal-
ing programme should be run. The factory
setting for the water hardness is 4�
You can check the water hardness using
the enclosed test strip or by asking your
local water supplier.
Dip the test strip briefly in water, gently
shake off any drips, and check the result
after one minute.
Level Water hardness
German (°dH) French (°fH)
1
2
3
4
1-7
8-14
15-21
22-30
1-13
14-25
26-38
39-54