Siemens TE502206RW - Manual (Page 18)

14
de en
8� Attach the milk frother to the steam
valve� Check that the red mark on the
steam valve is covered�
¡
Risk of scalding
Only use the appliance when the milk
frother (6) is completely assembled and
fitted.
Cleaning the brewing unit
Clean the brewing unit regularly.
To pre-clean the brewing unit automatically:
1� Select
e
by turning the rotary knob (14).
2� Place an empty glass under outlet (7).
3� Press the start button (10).
The appliance rinses.
In addition to the automatic cleaning
programme, the brewing unit (5a) should be
removed regularly for cleaning. (See figure
E at the start of the operating instructions.)
1� Switch the appliance off at the power
on/off switch O / I (9). No buttons are lit.
2� Open the door (5b) to the brewing unit.
3� Slide the red lock (5d) on the brewing
unit completely to the left.
4� Press the eject lever (5c) down fully. The
brewing unit is released.
5� Grasp the brewing unit (5a) by the
recessed grips and remove carefully.
6� Rinse the brewing unit (5a) thoroughly
under running water.
7� Hold the brewing unit sieve under the
running water.
Important: Do not clean with detergent or
other cleaning agents and do not put it in
the dishwasher�
8� Wipe out the inside of the appliance
thoroughly with a damp cloth and
remove any coffee residues.
9� Allow the brewing unit (5a) and the
inside of the appliance to dry�
10� Reinsert the brewing unit (5a) fully into
the appliance�
11� Press the eject lever (5c) up fully.
12� Slide the red lock (5d) fully to the right
and close the door (5b)�