Siemens TE502206RW - Manual (Page 10)

6
de en
“Drink selection” rotary knob
This rotary knob (14) is used
to select the required drink
and the per-cup quantity. It
is also used to change user
settings�
a
to
c
Small Espresso
Espresso
Small Café Crème
Café Crème
Large Café Crème
b
to
d
2 small Espresso
2 Espresso
2 small Café Crème
2 Café Crème
2 large Café Crème
e
Rinse machine
f
Rinse milk system
N.B.: If a drink is selected that cannot be
prepared, Invalid combination appears in
the display� Change the coffee strength or
the selected drink�
Milk frother
Pull the milk frother (6) out to open it and
push it back in to close it.
Display messages
The display (15) shows not only the current
operating status, but also various mes-
sages that give you status information or
let you know when you need to take action.
As soon as you have taken the necessary
action, the message disappears and the
menu for drink selection is displayed again.
Before using for the
first time
General
Fill the water tank with fresh, cold, uncar-
bonated water only, and preferably use
only beans for fully automatic coffee and
espresso machines. Do not use coffee
beans that have been glazed, caramelised
or treated with other additives containing
sugar, since they will block the brewing unit.
The water hardness setting can be adjusted
on this appliance. The factory default setting
for the water hardness is 4� Check the
water hardness with the enclosed test strip�
If the check reveals a value other than 4,
change the setting on the appliance accord-
ingly after switching on (see “Menu settings”
Water hardness on page 9)�
Switching on the appliance
1� Remove the protective film.
2� Place the fully automatic espresso
machine on a flat, water-resistant
surface that can take its weight. Make
sure that the machine’s ventilation slots
remain unobstructured.
Important: Only use the appliance in
frost-free rooms� If the appliance has been
transported or stored at temperatures below
0 °C, wait at least 3 hours before operation.