beautypg.com

Controlling general audio, Equalizer control, Controlling general audio equalizer control – Kenwood DNN770HD User Manual

Page 72: P.142), P.143)

background image

142

143

Return to the Top page

Audio Setting Up

Return to the Top page

Audio Setting Up

Controlling General Audio

1

Touch [Audio Control].

2

Set each item as follows.

Fader # / Balance #
Adjust the volume balance around the
touched area.
[

C] and [D] adjust the right and left volume

balance.
[

R] and [S] adjust the front and rear volume

balance.
Volume Offset*
Finely adjust the volume of the current source
to minimize the difference in volume between
different sources.
Subwoofer Level
Adjust the subwoofer volume. This setting is
not available when subwoofer is set to “None”.
See

Speaker setup (P.139)

.

Bass Boost (DNN990HD)
Set the amount of bass boost among “OFF”/
“Level1”/ “Level2”/ “Level3”.

Loudness (DNN770HD)
Turns the loudness control function on or
off. If turned on, high and low tones are
automatically enhanced during low volume.
Settable only when zone function

(P.147)

is

set to off.

* If you have increased the volume first, then

reduced the volume using the “Volume

Offset”, the sound generated if you

suddenly switch to another source may be

extremely loud.

Equalizer Control

You can adjust equalizer by selecting the

optimized setting for each category.

1

Touch [Equalizer].

Equalizer screen appears.

Ñ

DNN990HD operation

Controlling EQ curves

1

Select EQ curve from [Natural],
[Rock], [Pops], [Easy], [Top40], [Jazz],
[Powerful], [iPod], and [User].

NOTE

• [iPod] is available only during iPod source.

Controlling equalizer manually

The Graphic Equalizer cannot be set when

you select [iPod] in the Equalizer screen.

1

Touch [EQ] in the Equalizer screen.

2

Touch the screen and set the Graphic
Equalizer as desired.

Gain level (light green boxed area)
Adjust the gain level by touching the each
frequency bar.
Touching [

C], [D], [R] and [S] can also

adjust the level. Use [

C] and [D] to select a

frequency, and [

R] and [S] to set the level.

EQ INIT
Returns to the previous level which the gain
level is adjusted.
Flat
Tone curve becomes flat.
Bass EXT (Bass Extend Settings)
When turned on, the frequency lower than
62.5 Hz is set to the same gain level as 62.5 Hz.
Loudness
Set the amounts of boost of low and high
tones. “OFF”, “Low”, “High”
SW Level
Adjust the subwoofer volume. This setting is
not available when subwoofer is set to “None”.
See

Speaker setup (P.139)

.