Dake Dura Press Force - 10/20 - Manual (Page 6)

Force 10M /Force 20M6
6 06/10
Section 1.0
1.1 GENERAL INSTRUCTIONS AND DEFINITIONS
This handbook is an integral part of the product; IT MUST be carefully conserved for
future reference.
FOR ANY REQUEST FOR CLARIFICATION, ASK YOUR EMPLOYER OR THE
DAKE TECHNICAL SERVICE, AVOIDING ANY PERSONAL INITIATIVE THAT
COULD CAUSE VERY SERIOUS OR FATAL ACCIDENTS.
Before using the machine, read the warranty carefully.
DEFINITIONS:
- In this manual “right-hand side”, “left-hand side”, “forwards”,
“backwards”, “top” and “bottom” refer to the operator situated in
front of the press with the power unit to his right.
- In this manual, the units of measurement are expressed in the
international system SI (e.g. liquid capacity is expressed in liters).
1.2 DESCRIPTION
The machine described in this manual denominated HYDRAULIC PRESS Model
Dura Press has been specifically designed for use in operations where it is
necessary to use a force of compression that can be moved into different positions
even on the same part:
1. The PRESS BODY, made of high tensile carbon steel and thanks to its
monolithic structure, has considerable bending strength.
2. The HAND PUMP, placed on the right of the press allows with facility to reach
the work pressure.
3. The HYDRAULIC CYLINDER specially designed for the specific requirements
of use of the press. In addition to the special care for the internal surfaces
and of the rod, special low-friction gaskets have been used in it to optimize
the operations where special precision in the pressing action is required.
1.3 USE
The DURA PRESS/FORCE series press is mainly designed for operations of
straightening out sheet metal, profiles, and metal structures, in addition it can be
used to insert inserts (e.g. bushes, bearings, bushings, etc.), to remove inserts,
calking and all the operations where bending or cutting metal materials are not
carried out.
Other uses are not allowed unless the manufacturer expressly authorizes them.
The substance of the above mentioned operation will always be subordinate to the
maximum working capacity of the press.
THIS MACHINE IS DESTINED ONLY FOR THE USE IT HAS BEEN DESIGNED
FOR, ANY OTHER USE IS TO BE CONSIDERED IMPROPER AND THEREFORE
THE MANUFACTURER CANNOT BE HELD LIABLE FOR ANY DAMAGE
CAUSED BY ANY IMPROPER USE OR USE NOT EXPRESSLY MENTIONED IN
THIS USER’S MANUAL.