Dake Dura Press Force - 10/20 User Manual
Page 18
Force 10M /Force 20M18
18
06/10
Section 7.0
7.0 OPERATION
Before starting any operations, make sure there are no other persons in the
immediate vicinity of the machine.
IT IS STRICTLY FORBIDDEN TO PASS UNDER THE WORK TABLE.
7.1 CONTROLS
To make the press work you have to stroke the pump control lever.
The feed speed of the cylinder and the pressure will depend on the driving speed of
the pump control lever. The pressure starts to rise when the cylinder shaft is in
contact with the piece of press, continuing with the pump action the pressure rises
until to have the necessary valve to make the operation.
For the ram to retract, loosen the valve placed under the pump control lever. The
cylinder is equipped with a spring for the ram return.
7.2 HEIGHT ADJUSTMENT OF THE MOVABLE BASE
To get very good use of the press it is necessary to place the worktable at a correct
height depending on the operation to make and on the tooling to use.
1. To the size of the part to be pressed.
2. To any tooling placed on the movable table.
3. With the help of a second worker to lift the movable table.
4. To take away the pins and to place them in the holes of the correct height.
5. To lower slowly the worktable onto the pins.
6. To verify the positioning of the table and of the pins.
If the work position you wish corresponds with the max. width of the work size it is
not necessary to place the pins (that will be placed in a dry place) because we have
foreseen and prepared stops suitably welded to the stanchions.