Section 4 - maintenance, Maintenance safety, After 1st day and week of operation – Summers Superchisel - 3-Section User Manual
Page 79: Maintenance safety -1
4-1
SECTION 4 – MAINTENANCE
MAINTENANCE SAFETY
1. STOP engine, place all controls in neutral, set parking brake, remove ignition key and wait
for all moving parts to stop before servicing, adjusting or maintaining.
2. BE CAREFUL when working around high pressure hydraulic system.
3. ALWAYS make sure that pressure is relieved from hydraulic circuits before servicing or
disconnecting from tractor.
4. USE EXTREME CARE when making adjustments.
5. KEEP CHILDREN AWAY from machinery at all times.
6. NEVER ALLOW anyone to walk or work under a raised piece of equipment without install-
ing cylinder and transport locks.
MAINTENANCE FOR AFTER THE FIRST DAY AND WEEK OF OPERATION
1. Grease lift arms, walking tandem assemblies, and hitch pivot. (There are a total of 12 daily
grease zerks).
2. Check all hydraulic components for leaks daily.
3. Check tightness of all wheel bolts daily.
4. Check tightness of wheel bearings (See
5. Check tightness of the following bolts on
the trip assemblies.
6. Check tightness of all hardware. Pay
special attention to the hitch bolts and
all pivot retaining bolts.