Summers Superchisel - 3-Section - Manual (Page 75)

3-9
SECTION 3 – CHISEL PLOW OPERATION
6. Leveling machine from front to back.
16’ - 30’ Narrow: With chisel plow still in the ground, check depth of tillage in the front and the
back of machine. Level with hitch tilt cylinders.
32’ Standard - 44’: With chisel plow still in the ground, check depth of tillage in the front and the
back of machine. If leveling is necessary, use wrenches provided to adjust eyebolt on front wheel
assembly up or down.
The front center lift arm has two cylinder attach locations. If chisel plow has a full set of mounted
harrows or if rear of machine is low in transport position, use rear cylinder attach hole. Connect-
ing front center cylinder to rear hole will lower front end of chisel plow in transport position.
NOTE: It is best to check levelness of chisel plow after each adjustment by working test
strips within the field.
IMPORTANT!
Pressure must be removed from cylinders before adjusting eyebolts. Rest chisel plow on
top of the ground. Shut tractor off and relieve pressure by cycling remote lever.