Summers Superchisel - 3-Section - Manual (Page 56)

SECTION 2 – HYDRAULIC SET-UP (16’-30’ NARROW)
C. Leave plenty of slack by hitch pivot.
– The hitch pivot point will move up and down from transport position to field position. Hoses
must be loose enough to allow a full range of travel.
D. Continue to route hose for 6 x 10” cylinder along center section of chisel plow.
– Bolts welded to frame will help show correct routing.
E. Use care when stringing hose between center section and wing.
– Leave plenty of slack between points 1 and 2 (Page 2-50) as wing pivots up and
down during field operation. Hose must not stretch tight.
F. Hose must be routed so it will not be pinched when wing is folded into transport.
– Pull hose tight between points 2 and 3. This will prevent hose from contacting
transport lock (See page 2-50).
G. Route hose up cylinder attach to 6 x 10” cylinder.
H. Route hose from 6 x 10” to 5-1/2 x 10” cylinder along same path as first hose.
2-44
DISKCHSL-CLTRCHSL/DEPCONHYD 7/30/2012
8T1060
6.0" X 10"
8J5520
3/4"-16ORB X 10 JIC(M)
8J5520
3/4"-16ORB X 10 JIC(M)
8J5520
3/4"-16ORB X 10 JIC(M)
8D3212
MALE TIP, 3/4"-16ORB ISO
8R6810
SS BSHNG
8K9106
CYL PIN
8D9108
ROLL PIN
8T2990
3/4" HOSE CLAMP
8G2285
NYL. TIE (GREEN)
8T1008
PLASTIC
PLUNGER
REPAIR
KIT
8T1010
BOLT ON
POPPET
ASSY
8T1015
HPC
8J6020
3/4"-16ORB X 10 JIC(M) 90° ADP
8T1045
4.5" X 10"
8T1050
5.0" X 10"
8T1055
5.5" X 10"
8J6010
3/4"-16ORB X 6 JIC(M) 90° ADP
8J6020
3/4"-16ORB X 10 JIC(M) 90° ADP
8J6020
3/4"-16ORB X 10 JIC(M) 90° ADP
8J6020
3/4"-16ORB X 10 JIC(M) 90° ADP
8J6020
3/4"-16ORB X 10 JIC(M) 90° ADP
8N6570
3/4" X 570"
8N4198
1/2" X 198"
8N4198
1/2" X 198"
8N4228
1/2" X 228"
CYLINDER PORTS
TOWARDS FRONT
OF MACHINE
24'-30' MACHINES
DEPTH CONTROL HYDRAULICS
TOP VIEW
8N3534
3/8" X 534"
TO
TRACTOR
TO 5.5"
CYL.