Summers Superchisel - 3-Section - Manual (Page 57)

SECTION 2 – HYDRAULIC SET-UP (16’-30’ NARROW)
2-45
I. Use nylon ties to hold first hose to second hose.
– This hose must be attached to base end (top) of 5-1/2 x 10” cylinder.
J. Route 1/2 x 228” hose from 5-1/2 x 10” to 5 x 10” cylinder.
– This hose must go from rod end (bottom) of 5-1/2 x 10” to base end (top) of 5 x 10” cylinder.
K. Route 1/2” x 198” hose from 5 x 10” to 4-1/2 x 10” cylinder.
– This hose must be routed through points 1, 2 and 3 as explained in steps E and F.
– The hose must go from rod end (bottom) of 5 x 10” to base end (top) of 4-1/2 x 10”.
L. Route hose from 4-1/2 x 10” to front of hitch.
– This hose must follow the same path through points 1, 2, and 3.
– Continue to route hose along center frame and hitch. Bolt locations will help show desired
location for routing.
– Nylon ties should be used by the hose holder loop to keep hoses together.
16'-28' NRRW HYD HITCH 2/9/2012 9T2012H.iam/
8N3150
2X
16' - 30' NARROW CHISEL
HYDRAULIC HITCH
8C1710
3/8 X 8 X 9"
8X0202
3/8" LN
8W1398
8X0260
3/4" N
8X0306
3/4" LW
8X0120
3/4" X 9"
8CC4012
8CC4010
8J6010
3/4-16ORB X #6JIC(M) 90° ADP
8P7250
8X0285
1 1/2" N
8T2040
8J5300
#6 JIC(M) TEE
8J5700
#6 JIC(F-SW) X #6 JIC(M) 90° ADP
8N3060
2X
8N3048
2X
8J5510
3/4" ORB X #6 JIC(M)
8D3212
3/4" ORB TIP ISO