Summers Superchisel - 3-Section - Manual (Page 74)

3-8
SECTION 3 – CHISEL PLOW OPERATION
5. Leveling chisel plow from side to side. Stop tractor with machine in the ground. Check depth of
tillage on the left wing, center, and right wing. If leveling is necessary, use wrenches provided to
adjust eyebolts on cylinder attachments located at rear of chisel plow.
*NOTE: Insure that cylinder attach holes are aligned when eyebolts are tightened.
One turn of 1-1/2” NC Cylinder Attach Eyebolt Nut changes chisel height 3/8”. One inch of cylinder
stroke moves chisel plow height over 2 inches. Therefore, it may only be necessary to move eyebolts
a small amount to attain correct adjustment of each section.
IMPORTANT!
Pressure must be removed from cylinders before adjusting eyebolts. Rest chisel plow on
top of the ground, shut tractor off and relieve pressure by cycling remote lever.