High Country Tek emc-1V User Manual
Page 6
Part No:-
021-00351 Rev 1.0
emc-1P & emc-1V e-Fan System Controller User Guide
Page 6
e-Fan Cooling System Controllers
with J1939 Interface
Product Overview
NO software experience needed to apply this controller successfully.
Pre-written ‘e-Fan Drive’ software for easy, fast system configuration, development and production.
Intuitive Graphical User Interface (GUI) runs on any PC with Windows® XP or newer software (.net
compatible).
9 – 32VDC operation with full reverse polarity and SAE J1455 protection.
CE approved to latest international test standards.
J1939 CAN Bus communications for engine and temperature zone data Inputs
**
J1939 temperature data hard coded for:
SPN 109, Engine Coolant Temperature; PGN 65262,
SPN 177, Transmission Oil Temperature; PGN 65272
SPN 105, Engine Intake Manifold 1 Temperature; PGN 65270
Extended -40ºC (-40ºF) to +85ºC (+185ºF) controller operational temperature range.
All inputs and outputs are protected from shorting to ground or the power supply.
Diagnostic LEDs display I/O status and module operation at a glance.
‘Blinking’ error codes for fast on-site ‘health check’.
System wiring and coil fault detection alarms.
Configurable Alarm output for integration into host system.
IP68 (NEMA 6P) rating on module for harsh environment reliability.
Deutsch IP69K connectors for reliable and easy system wiring.
Separate RS232 communications connector for programming, monitoring and diagnostics.
Rugged encapsulated product withstands harsh environments found in mobile applications.
Non Volatile Memory maintains ALL settings without power
Completely user configurable and settings are password protected.
**
J1939 PGN Address Note
**
If the standard SAE J1939 PGN address for Temperatures or RPM is NOT compatible for a
particular application, HCT can change the PGN numbers as needed and re-issue personalized
program code to you. Please use the contact numbers on the back page of this manual to discuss
this with our customer support personnel.