AT&T CL84200 - Manual (Page 33)

27
Set date/time
The answering system announces the day and time of each message prior
to playing it. Before using the answering system, set the date and time as
follows. If you subscribe to caller ID service, the day, month and time are
set automatically with each incoming call. The year must be set so that the
day of the week can be calculated from the caller ID information. You can
turn off the date and time settings of the caller ID service and use your own
settings for each incoming call (see the
Use caller ID to automatically set
date and time section on the following page).
After a power failure or handset registration, the system reminds you to set
the date and time before entering idle mode.
Follow the steps below to set the month, day, year and time on the
telephone base.
1. When the telephone base is in idle mode, press MENU/
SELECT
to enter the
main menu.
2. Press q /CID or p/DIR to scroll to >Settings, then
press
MENU
/SELECT.
3. Press q /CID or p/DIR to scroll to >Set date/time.
4. Press
MENU
/SELECT twice to select >Date & time.
5. Press q /CID or p/DIR to choose the month then
press
MENU
/SELECT, or enter the number using the
dial pad keys.
6. Press q /CID or p/DIR to choose the day then
press
MENU
/SELECT, or enter the number using the
dial pad keys.
7. Press q /CID or p/DIR to choose the year then
press
MENU
/SELECT, or enter the number using the
dial pad keys, then press
MENU
/SELECT to confirm.
8. Press q /CID or p/DIR to choose the hour then
press
MENU
/SELECT, or enter the number using the
dial pad keys.
9. Press q /CID or p/DIR to choose the minute then press
MENU
/SELECT, or
enter the number using the dial pad keys.
10. Press q /CID or p/DIR to choose AM or PM, then press
MENU
/SELECT
to confirm. There is a confirmation tone. Press CANCEL to cancel.
NOTE: If the clock is not set when a message is recorded, the system announces, “Time
and day not set,” before it plays the message.
Telephone base settings
Telephone settings
> Set date/time
Home area code
> Date & time
CID time sync
SET DATE
--/--/--
SET TIME
--:-- --