ARI Armaturen ARI-PREMIO - Manual (Page 48)

Page 48 0040501000 4511
Operating and installation instructions
Thrust actuator ARI-PREMIO
5.5.14.4 Technical data - Position indicator RI32
5.5.14.5 Potentiometer installation
Plug Ra, Rb, Rc connector from potentiometer cable of RI32 position indicator into
pin strip 25, 26, 27 or 28, 29, 30 of the ARI-PREMIO.
Type RI 32 Position indicator
Supply voltage V 24V DC / AC 50...60Hz
Potentiometer input Ω 1 kOhm ... 10 kOhm three-conductor connection, suitable for
conductive plastic potentiometer
Control signal output,
voltage V 2...10 V DC with (control signal output with supply voltage
internal electrical connection)
Control signal output,
current mA 4...20 mA DC (load max. 500 W)
(control output signal with supply voltage internal electrical
connection)
Measuring current at
potentiometer arm μA max. 800 μA
Linearity error % ± 0,2 % measurement range
Temperature coefficient %/K 0,04 %/K
Auxiliary energy inflow %/V 0,02 %/V
Protection type EN 60529 IP40 (terminals IP20)
Max. ambient temperature °C -40 °C...+85 °C
Humidity % 95 % r.F., no dewing
Weight g ca. 35 g
Dimensions mm Ø x depth 44 x 38
Connection / installation RI 32 Position indicator
Electrical connection using screw terminals max 2,5 mm
2
Built into thrust actuator in ARI-PREMIO all versions
ATTENTION !
When installing the potentiometer please note point „5.5.4 Potentiometer“ in
these Operating Instructions.