ARI Armaturen ARI-PREMIO - Manual (Page 10)

Page 10 0040501000 4511
Operating and installation instructions
Thrust actuator ARI-PREMIO
Accessories
Trip slide Necessary for operation:
- for actuating travel switch S3 / retracting spindle
(the travel switch S3 exists already in the standard version of the actuator)
- for potentiometer
- for additional position switches S4 / S5
Additional intermediate
position switches
S4, S5
4)5)
Type Standard - 2 pcs., zero potential, switching capacity 10A, 250V~
Type Low-voltage
- 2 pcs., zero potential, with gold contacts,
switching capacity max. 0,1A, 4-30V
Potentiometer 4)
Conductive plastic
(max. 2 pcs.)
- 500, 1000, 2000, 5000 ohm; 1 W
Wire (max. 2 pcs.) - 100, 200 ohm; 1 W
Contactless (max. 1 pc.)
- Only in conjunction with RI22
- Feedback signal corresponds to RI22
TÐúV-approved
potentiometer
(max. 2 pcs.)
- TÜV-approved conductive plastic potentiometer, suitable as a
position feedback sensor for control devices in electronic systems
used to regulate and monitor fuel, air and exhaust gas streams in
combustion plants
- 5000 ohm
- Or optionally: 100, 200, 500, 1000 ohm; 1.5 W
- Not suitable for retrofitting!
Electronic
position controller
4)
(for controlling actuator with
analogue control signal)
Type ES11
- Control signals 0(2)...10V or 0(4)...20mA; electrical isolation
between mains voltage and control signal
- Incl. potentiometer
(note the maximum number of potentiometers)
Type PREMIO-Plus
(see separate data sheet /
operating instructions)
- Control signals: 3-step, 0-10V or 4-20mA
- Automatic initialisation
- Optional position feedback
- Electrical isolation between mains voltage and control signal
Electronic
position indicator
4)
(for position feedback with
analogue control signal)
RI22
- Analogue output for position feedback 0(4)...20mA, optional
switching to 0(2)-10V, output can be inverted; electrical isolation
between mains voltage and position feedback signal
- Optional display for indicating position feedback signal in mA or V
- Incl. potentiometer
(note the maximum number of potentiometers)
RI32
- Analogue output for position feedback
2...10V; 4...20 mA
- Compact design; 2 or 4-wire circuit
- Power supply: 24V AC/DC
- Incl. potentiometer
(note the maximum number of potentiometers)
Heating Heating resistor
- (With automatic switching circuit)
230V AC, 115V AC, 24V AC, 15W
Connection board 4)
Type Standard PA
- Zero potential, switching capacity 10A, 250V~
- (Also possible with standard version for operation at 12/15kN)
Type Low-voltage NA
- Zero potential, with gold contacts,
max. switching capacity 0.1A, 4-30V