HighPoint RocketRAID 2240 User Manual
Page 65
for FreeBSD 4.11-RELEASE
ok load disk1:hp tmv6-4.11.ko
for FreeBSD 5.0-RELEASE
ok load disk0:h ptmv6-5.0.ko
for FreeBSD 5.1-RELEASE
ok load disk0:h ptmv6-5.1.ko
for FreeBSD 5.2.1-RELEASE
ok load disk0:hp tmv6-5.2.1.ko
for FreeBSD 5.3-RELEASE
ok load disk0:h ptmv6-5.3.ko
for FreeBSD 5.4-RELEASE
ok load disk0:hptmv6-5.4.ko
for FreeBSD 5.3-AMD64-RELEASE
ok load disk0:hptmv6-5.3-amd64.ko
for FreeBSD 5.4-AMD64-RELEASE
ok load disk0:hptmv6-5.4-amd64.ko
5.
After the driver has been loaded, remove the floppy diskette from the floppy
drive.
6.
Type in “boot” and continue with installation as normal. Refer to FreeBSD
installation guide for additional information.
ok boot
Note: On some systems, when ACPI is enabled, FreeBSD may not function
properly. Try disabling ACPI in the motherboard’s BIOS settings, or type the
command “set hint.acpi.0.disabled=”1”” under the boot prompt, in order to
solve the problem.
7.
Before exiting installation, an additional step must be taken to copy the RR2240
driver module to the system. On the driver diskette, there is a setup script labeled
FreeBSD Driver Support
6-3