3 – updating the driver, 4 - uninstalling the driver – HighPoint RocketRAID 2240 User Manual

Page 61

3 – Updating the Driver

To update the driver, simply reinstall the driver following the steps in previous

section, “ Install RocketRAID 2240 Driver on an Existing System “.

Note: If the driver is loaded in initrd (when system is installed onto a disk or array

attached to the RocketRAID 2240), you need to run the mkinitrd command to update

the initrd file. If you are using the lilo boot loader, run lilo again (# lilo).

4 - Uninstalling the Driver

To uninstall the RocketRAID 2240 driver

Note: The driver cannot be uninstalled while the system is booted from a disk or array

attached to the RocketRAID 2240.

To uninstall the driver, remove the lines added to /etc/modules.conf and /etc/fstab.

Linux Driver Support

5-14