HighPoint RocketRAID 2240 - Manual (Page 14)

4 - Verifying Installation
Once the RocketRAID 2240 host adapter and hard disks have been installed into the
chassis, boot-up the system to verify that the hardware is properly recognized.
1. Power on the system. If the system detects the presence of the adapter, the
RocketRAID 2240 BIOS will be displayed.
2. Press Ctrl+H to access the RocketRAID 2240 BIOS Utility.
The BIOS Utility will display information about hard disks attached to the adapter.
Make sure all attached disks are detected by this utility. If any of the hard disks are
not detected, power down the system and check the power and Infiniband cable
connections. Make sure the hard disk in question is securely installed into the
corresponding removable drive tray.
RocketRAID 2240 Hardware Description/Installation
2-4