Vaisala vNet PoE Network Interface - Manual (Page 9)

vNet User’s Guide 3
the power supply barrel-end connector into the Device and
turn 1/4 to the right (Figure 2).
Figure 2: Connecting to an external power supply
• When power is supplied to the vNet Device, the red
power LED will blink for 7-8 seconds, then stay on.
• When a network connection is made, the LNK LED will
light up and stay on, and the ACT LED will blink
intermittently.
Installing Drivers
Device drivers are required on each PC to which a vNet Device is
connected. This allows Vaisala Veriteq software (viewLinc and
vLog) to communicate with the Loggers attached to the vNet
Devices on your network.
Your vNet installation CD provides you with two device drivers: a
device driver for vNet Devices which are installed on the same
subnet as your PC, and a device driver for vNet Devices on a
different subnet. If your PC is on a different subnet than the vNet
Device, see page 6.
Note:
If you use viewLinc 4.3 or higher, and are installing
vNet devices with serial number 1411xxxx
or
Firmware 1.4 , or higher, enabling the viewLinc Aware
Service ensures device drivers are installed
automati-cally. Refer to the viewLinc User’s Guide to
learn how to enable the viewLinc Aware Service.