Vaisala vNet PoE Network Interface User Manual
Page 30
24
VAISALA
To save configuration settings:
1
From the vNet Configuration and Management interface,
choose
Utilities | Backup/Restore
.
2
Select the
Backup
tab and click
Backup
.
NetBios-
Name
The NetBIOS name used to access the vNet Device.
The name must be 1 to 15 characters long (you can use
any alphanumeric combination and the underscore
character, _ ).
EthDuplex
The Ethernet mode the vNet Device uses on the net-
work on which it is installed. Valid duplex values are
Half or Full.
CloseTime-
out
The control setting to enable or disable the web inter-
face idle timeout. Valid values are true or false.
IdleTimeout
The timeout value in minutes (1 to 120) used if the Clos-
eTimeout = true.
HttpPort
The TCP port number the vNet Device uses to display
the web interface.
Device-
Name
The vNet Device name displayed in the Digi Device Dis-
covery software. The name can be up to 63 characters
in length.
Contact
An informational description saved in the vNet Device.
The description can be up to 63 characters in length.
RealPort
The TCP port number the RealPort driver uses to
access the serial port on the vNet Device.
RawPort
The TCP port number the Raw TCP driver uses to
access the serial port on the vNet Device.
EnableFan
The control setting for the vNet Device fan. Valid values
are on or off.
Enable15V
The control setting to enable or disable the 15V loop
power supply output. Valid values are true or false.
Item
Configuration
Table 1: Configuration Backup File