Vaisala vNet PoE Network Interface - Manual (Page 12)

6 VAISALA
To install drivers for Devices on a different subnet:
Note:
vNet Devices are installed with Digi Driver software
(all Setup Wizard screens refer to Digi Drivers).
1
Insert the Vaisala vNet and Digi Device Drivers CD into the
PC where the drivers are to be installed.
If the Software Installation menu does not display automati-
cally, click
Start
on the Taskbar, then select
Run
. Type
D:\setup.exe
(replace ‘
D
’ with the drive letter of your CD-
ROM drive), then click
OK
.
2
To check for most recent updates to the software installation,
click
Documentation Index
.
•
vNet PoE Readme
- review for updates to information in
the User’s Guide.
•
Digi Documentation Index
- select the desired document
for the Digi Device you are using.
3
On the Software Installation window, click
vNet RealPort
Setup
.
• If the Welcome screen asks you to ensure that the vNet
Device is powered up and connected to the network,
disregard the message and click
Next
.
• If the
Add a New Device
option is displayed, select it, then
click
Next
.
4
On the
Select Device
window, scroll to the bottom of the
device list, wait until “Searching...” is no longer displayed,
select
, then click
Next
.
5
On the
Describe Device
window, enter the Device Model
Name (this name is on the serial number label, for example,
CDL-VNET-P).
6
In the
Network Settings
area complete the following:
• Enter the
IP Address
obtained from your IT Department.
• Set
No. Ports
to 1.
• Set
Starting COM
to the lowest COM port number that the
Setup Wizard displays.