Vaisala vNet PoE Network Interface - Manual (Page 15)

vNet User’s Guide 9
If the vNet Device does not appear in the list, wait a few sec-
onds, then click
Refresh view
. Select the Device, then, in the
Device Tasks
area, click
Configure network settings
.
6
To change network settings, on the
Configure Network
Settings
window, select
Manually configure network settings
,
then enter the IP Address, Subnet Mask, and Default
Gateway values for this vNet Device. Click
Save
.
7
On the
Device Tasks
menu click
Restart device
, then click
Restart
. Wait until the vNet Device restarts and the device list
updates.
8
Repeat steps 5 through 7 for each additional vNet Device.
Configuring vNet Devices
The vNet Device has a web-based vNet Configuration and
Management interface which allows you to make configuration
changes, restore default settings, and more. It is recommended
that you log in to this interface to change the default password.
If you have enabled the viewLinc Aware Service in viewLinc,
for vNet devices with serial number 1411xxxx or Firmware 1.4
,
or higher:
• Configuration is completed automatically for all vNet Devices
on the same subnet as the viewLinc Server.
• For vNet Devices on a different subnet from the viewLinc
Server, you are only required to configure one vNet Device.
Additional vNet Devices are configured automatically.
To launch the vNet Configuration and Management interface from a
Web browser:
1
In a Web browser, enter the IP address of your vNet Device
(obtained from your IT administrator) or enter the NetBIOS
name. The default NetBIOS name is VERITEQXXXXXXXX
(X denotes the 8-digit serial number of the vNet Device). If
the vNet Device is configured with a TCP port for HTTP other
than the default value of 80, enter the port number after the
IP address or NetBIOS name, separated with a colon.