Vaisala vNet PoE Network Interface - Manual (Page 19)

vNet User’s Guide 13
The factory default NetBIOS name is VERITEQXXXXXXXX
(X denotes the 8-digit serial number of the vNet device).
To change the NetBIOS name:
1
From the vNet Configuration and Management interface,
choose
Configuration | Network | IP Settings.
2
In the NetBIOS name field you can enter up to 15 characters
(using letters, numbers, and underscores). To avoid a
network conflict, do not assign the same name to another
vNet Device.
3
Click
Apply
. When prompted, click the
here
link to restart the
vNet Device.
Ethernet Settings
Depending on the network hub or switch the vNet Device is
connected to, you may want to change the Ethernet mode from
the default setting, half-duplex, to full-duplex.
To change the Ethernet settings for your vNet Device:
1
From the vNet Configuration and Management interface,
choose
Configuration | Network | Ethernet Settings
.
2
Choose the desired Duplex Mode (Half or Full).
3
Click
Apply
. When prompted, click the
here
link to restart the
vNet Device.
Note:
The speed setting is fixed at 10Mbit and cannot be
changed.
Serial Port Settings
The vNet Device communicates with the Vaisala Veriteq Logger
through a serial port; however, communication between the PC
and the vNet is through TCP ports.
Because TCP port numbers can change, use the Serial Port
Settings screen to configure the vNet Device to continue to use