Vaisala MMT162 - Manual (Page 39)

Chapter 4 ________________________________________________________________ Operation
VAISALA _______________________________________________________________________ 37
Serial Line Output Commands
Start Measurement Output
Use the R command to start the continuous outputting of measurement
values as an ASCII text string to the serial line. The format of the
measurement message is set with the FORM command.
R
Example:
r
aw= 0.261 T= 23.8 'C H2O= 15 ppm
You can change the format of the output with the following commands:
- Outputting interval can be changed with the INTV command.
- Output message format can be changed with the FORM command.
Stop Measurement Output
Use the S command to end the RUN mode. After this command all other
commands can be used. You can also press the Esc button or reset the
transmitter to stop the outputting.
S
Since the interface is half-duplex, you must enter the command when the
transmitter is not outputting. Give the command again if the transmitter
continues to output measurement messages.
See SMODE command on page 33 to change the default (power-up)
operation mode.