Posey Bed 8070 - Manual (Page 15)

Posey Bed 8070 15
The Posey Bed 8070 has an electronic bed control that adjusts bed height and head and knee
positions. The double insulated power cord can be plugged into a 110-volt receptacle.
The bed control should be stored in the bed control pocket. The
cord can be clipped out of the way using the bed control clip. This
ensures that the bed control is out of the patient’s reach.
The bed control will lower the mattress height to 19 inches (48 cm) when the patient is
unattended. The four ( 4) transfer brakes (see page 16) will engage when the bed is set at its lowest
position to eliminate accidental movement.
The bed mattress can be raised to 30 inches (76 cm).
Make sure the bed is connected to an appropriate AC outlet and inspect the cord for any visible
kinks or cuts. Press each operation button before use to ensure the bed control is not damaged.
introduction
Bed Control
Bed height
how to use the Bed
Control
adjust the Bed
heaD OPeRatiON:
1 - Push button to raise head
2 - Push button to lower head
kNee OPeRatiON:
3 - Push button to raise knee
4 - Push button to lower knee
BeD heiGht OPeRatiON:
5 - Push button to raise bed
6 - Push button to lower bed
1 3
2 4
5 6