Pop & Lock PL9772 User Manual
Pop & Lock For the car

PL9555 (and PL9772)
Power Lock
Installation Instructions
1) Locate and remove the Emergency
Release Handle with Phillips screw.
2) Locate and remove
the black plastic
Dust Cover if one is
installed. May need
to cut it off if
necessary.
3) Install the Lock
Module by sliding it
over the handle, be
sure the mounting
tab is at the bottom
and lines up with the
notch in the handle
when sliding it on.
POWERED BY:
(800) 342-5911
This manual is related to the following products:
Table of contents