Pop & Lock PL1600C - Manual

2.
Squeeze the top edge of the black
plastic insert down to release the
top two locking tabs, carefully to
prevent breakage.
3.
Remove the plastic insert by
pivoting it on the bottom edge.
4.
Insert the POP&LOCK bracket at an
angle on the drivers side and push it
all the way to the left to clear the
passenger side actuating rod.
5.
Now slide the POP&LOCK to the
right so that the mounting bracket is
positioned under the actuating rod
on the passenger side.
Insert the bolts and washers and
capture the bracket loosely with just
a few turns of the bolts.
Contents:
Lock Assembly, 2 keys
1/4-20 One-Way Screw (2)
1/4-20 Hex Bolt (2)
Small Washer (2) ID 0.32”OD 0.75”
Instructions, Warranty Card
Tools Required:
3/16 Allen Wrench or # 30 Torx
7/16 Socket or Adjustable Wrench
Tech Support:
Call 1-800-342-5911
6.
Carefully slide the plastic insert in
and click it into place.
7.
Tighten the mounting bolts.
1.
Loosen all three bolts of the handle,
push the handle up as high as it will
go and tighten the top bolt. Remove
the bottom two bolts (see Fig. 7)
Note: Bedliner panel may have to be
removed.
Installation Instructions
Tailgate Lock PL1600 Chevy S-10/GMC Sonoma‘94-’04, Isuzu Hombre ‘96&Up
11-20-07