Pop & Lock PL1350C - Manual

Installation Instructions
Tailgate Lock
PL1350C
(codeable lock)
Package Contents: Locking Bezel,
Replacement Handle
Instructions
1 Bolt 1/4" x 2”
1 Washer 1 1/2"
Tools Required:
1/2" Socket
10 mm Socket,
Small Flat Head Screwdriver
Chevy Silverado/ GMC
Sierra 1500
2007 & up
(New Body Style)
Full handle replacement
Chevy Silverado/ GMC
Sierra 2500/3500
2008 & Up
(New Body Style)
Full handle replacement
STEP 1 - Lower tailgate and remove the bottom center bolt on the inside
(backside) of the tailgate. Gently shut the tailgate. Remove the plastic bezel
by carefully prying with a flat head screw driver (it is recommended to use a
rag or cardboard between the tailgate and screwdriver so not scratch the
paint) in the bottom center to pop the bezel clip out of the tailgate. Next
gently pry at the upper two corners to release the bezel clips (again it is
recommended to use a rag or cardboard between the tailgate and
screwdriver so not scratch the paint). The tailgate should look like the
picture shown.
STEP 2 – Remove the latch rods from the latch rod clips. Do this by turning
the clip off the rod and pulling the rod out of the clip. Remove the other two
bolts on the inside (backside) of the tailgate. Hold the handle at the same
time to keep it from moving as you remove the bolts. Next remove the OEM
handle from the tailgate. Remove the bolt that holds the Pop N Lock
components together (do not discard the bolt and washer as they will be
used) and install the handle assemble in the tail- gate in the same place as
the OEM handle. Reinstall the two upper bolts. The bolts go through the
inside (backside) of the tailgate and thread into the handle assembly. Do not
tighten yet, leave a little loose to allow the handle to move.
STEP 3 - Insert the latch rods into the rod clips and snap the clips onto the rods.
Install the Pop N Lock bezel. Make sure the lock arm aligns to go into the square
opening on the handle assemble. Snap the bezel clips into the tailgate. Place the
bolt and washer (was removed to separate the components) into the bottom center
hole on the inside (backside) of the tailgate. This will thread into the back side of the
bezel. You may have to slightly move the handle bezel assemblies to get the bolt to
start to thread. Once it starts to thread tighten bolt. Then tighten the other two bolts.
STEP 4 - CAUTION: Only insert key intended for everyday use. (can only be coded once)
1. Remove protective label.
2. Fully insert key intended for everyday use
3. Rotate key clockwise until it stops while maintaining full key insertion. Lock is now fully coded and ready for
everyday use.
4. Test lock for proper operation. Turn key clockwise for lock and counter clock for unlock.
Technical Support:
Call 1-800-342-5911
[email protected]